The European Journal of Orthodontics Advance Access published online on June 1, 2009
The European Journal of Orthodontics, doi:10.1093/ejo/cjp029
The effect of constant height bracket placement on marginal ridge levelling using digitized models
* Department of Orthodontics, Université de Genève, Switzerland
** Department of Odontostomatology, Universitat de Barcelona, Spain
Address for correspondenceDr Carlos Suárez, Université de Genève, Faculté de Medecine, Section de Médecine Dentaire (Division d’Orthodontie), Rue Barthélemy-Menn 19, 1205 Genève, Switzerland, E-mail: carlos.suarez{at}medecine.unige.ch
 |
Abstract |
|---|
Bracket placement is an important phase of orthodontic treatment. Final compensatory archwire bends or bracket repositioning may be avoided if brackets are accurately positioned at the outset, so as to correctly express their built-in prescription. The purpose of this study was to investigate the levelling of marginal ridges when a bracket placement protocol, with fixed values from the incisal edges and occlusal surfaces, was used on digitized models. A computerized tool, OrthoCAD®, was used to predict the end result using virtual set-up software. The appliances used for digital simulation were 3M MBT Victory Series 0.022 inch with a 0.019 x 0.025 inch stainless steel final archwire on 42 digitized models. A paired t-test was used to investigate differences between the means of the pre- (T1) and post- (T2) treatment marginal ridge heights.
The results showed that most of the marginal ridge points studied deteriorated during digitized treatment prediction compared with T1. Statistical and clinically significant changes (P < 0.05) were found for upper premolar and lower molar marginal ridge points. Variability in the facial contour of the teeth seemed to play an important role.